1.Purpose
The Device for curle mixture formationp
ECOTOPp (the development of the member-cortexes. The
It greatly
perfects playfulness motor, brings about spare fuel and on order reduces
toxicity an exhaust gas DVS. Falls the surge bad material with perfected gas auto
facilities category M1 and N1 with karburator engine that allows to provide
execution them ecological requirements GUEST R 41.83 when test on typep Ap on
town drive to cycle and requirements GUEST 17.2.2.03 on contents of the oxides
of carbon and hydrocarbon on mode of the castrated move of the engine.
The
Advantage device for maximum spare fuel and increasing playfulness automotor reveals itself on all gasoline car in maximum degree exactly in town
cycle go;drive - with often change state of working automotor.
The Devicep ECOTOPp allows to perfect the features of the engine:
- an improvement playfulness car on 30%;
- an increase engine sizepp before
20 %;
- an economy fuelpp before 15 %
(when functioning(working) the engine on been singled movepp before 30 % );pppp-a reduction to toxicity exhaust gas in
8-14 once;
2. The
Technical features.
The Main
parameters:
the lengthpp 110 mms; the widthpp 60 mms;pp
the heightpp 14 mms; masspp (not more ) 125 gr.
The Worker temperature surrounding ambiences frompp 40 hails.T before + 50 Since Lifetimepp not less 5 years.
3. Kit of
the supply:
3.1. The Devicep ECOTOPp - 1-ª.
3.2. The
Laying insulating - 2 sht.
3.3. The
Brad M8 (udlinyonnaya) 4 sht.
3.4. The
Carbine M 8 -2 sht.
3.5. The
Tube 3¿ 1,3 -100üü -1 sht.
3.6. The Filter
air -1 sht.
3.7. The
Passport - an instruction -1 sht.
Before
installing device necessary to screw .
4.
Installation on engine.
Devicep ECOTOPp is fixed
between carburettor and soaking up collector of the engine of the car (thick
part ring is directed upwards, finepp
downwards)
When
installing devicep
ECOTOPp on DVS necessary:
4.1.
Disconnect the air filter from carburettor, pullings of management, fuel leadingp (inverse) at
presence;
4.2. Unscrew
nuts of the fastening the carburettor and remove him(it)
withp soaking up collector
4.3. Remove
staff insulation laying.
4.4.
Vyvernuti staff (short) of the brad from inlet collector and screw the brads M8
applicable to device ( except front drive a\m VASES).
4.5. Install
the devicep ECOTOPp (the narrow butt end ringpp injector downwards) on brads soaking up
collector , beforehand having installed overhand and from belowp ECOTOPp
heatinsulation playings from
kit device.
4.6. Install
the carburettor on brads and bolt the device a nut Attention: effort ÷ðª öúø nut must be not more than 0,7-
1,6 N.M.
4.7. Join
hose to air filter, pullings of carburettor management, connect the fuel bringing pipe
to carburettor after his(its) montage.
4.8. Start
the engine and warm up him(it) before worker of the
temperature.
4.9. If
after installingp ECOTOPp frequency of the rotation of the engine on
been singled move increases, necessary to reduce her(its) screw an amount on
carburettor, before frequency of the rotation on been singled move) in accordance
with standard specifications of the manufacturer of the car (as a rule turns
h.h. form 900 about/mines).
4.10.p Attentively track
for hermeticity of the installation device. Not penetration of the air is
allowed in places of the butting with flange of the carburettor and inlet pipe
line of the engine.
4.11.p If installation device on car contents oxides
of carbon in perfected gas of the engine was in the beginning below 0,5% or
stated on car carburettor was found on limit of the efficient impoverishing
fuel mixture and herewith exists instability of the functioning(working) the
engine on
been single move
or breaches driving quality of the car (twitches when moving or
collapses at
period of the runaway), necessary to enlarge degree of the enrichment by screw
quality carburettor, adjust advance angle of the ignition on impoverished fuel
mixture, but at impossibility of the eliminating the revealled defect addresses
to producer for consultation
4.12. When
installing device on car and under each undertaking adjust work on system of
the feeding and lighting the engine must be conducted checking the contents of
the oxides of carbon and hydrocarbon in perfected gas of the engine on mode of
the castrated move on GUEST 17.2.2.03.
Attention!!! The
Devicep ECOTOPp must close at car, having technically
fault-free engine (the system of the ignition, system of the feeding by fuel).
5. The
Principle of the work devicep
ECOTOP .
5.1. Devicep ECOTOPp is an efficient mixer component fuel mixture
for ð/ü, provides best melange a fuel with air and in
addition forms twist in the manner of curl flow TVS in enter
collector, and hereinafter, in camera of combustion that is provided by
entering additional air stream under throttle damper of the carburettor, tangential
flow fuel-air mixture, and hereinafter
through special ú³v³¡ð-injectors, which are also directed tangential and
under determined ³óv³ü to normals
of the axial flow fuel mixture. Formed thereby curlp leads awayp flow TVS itself and occurs formation an òø¿¨õò³ó³ flow most fuel-airp
mixture.
5.2.
Kolica-injectors applicable in devicep
ECOTOPp is specially calculated
with provision for aerodynamicsp flow
fuel mixture in enter collector and not only do not render the aerodynamic
resistance a mainstream TVS (as other device of the type ÿ¨³¿ªðòúø with blade, propeller, separate, and usual hole in
collector), but also effectively help him to find mathematically calculated,
ideal aerodynamic characteristic curl flow, which effectively
flares up and in greater depth burns in camera of combustion of the engine.
5.3. The
Additional air blast directed under double corner to the general flow fuel
mixture through special ring of the injector, curl her(it).
Kolica injectors were calculated with provision for aerodynamics, and not only
do not render the resistances, but also effectively help the flow to find the
ideal characteristic of the curl. Impoverished and transformed in curl mixture
burns much effectively. In this possible make sure, measure after installing
ECOTOPA factors WITH and SN and got in usages observable spare fuel. This
device passed certified test in US (g.
The
Certificate of the correspondence to p-ROSS.RU.MT14.B09304 TO
459-001-5664-7860-2002
6. The
Technical maintenance.
6.1.p The Device simply
and safely and for the whole period of the usages does not require undertaking
some special regulations work on maintenance him(it) in runnable condition.
6.2. For the whole period of the usages devicep ECOTOPp
condition of the engine, including carburettor and systems of the
ignition must be up to quality standard specifications on auto
facility.
6.3.p Through
each 10 000pp 15 000 km. run necessary to
change the air filter a devicep ECOTOP .
7. The
Warranties of the manufacturer.
7.1. The
Product is made in accordance with THAT 4591-001-56647860-2002.
7.2. The
The
Enterprise-manufacturer: KBp
NITRONp g. Samara. Date of
the issue: March 2006
Packer:
OOOp New packing
tel/fax. (846)
336-86-67
E-mail:
upakovka@ rambler.ru
Device for
preparation
fuelpp air mixture
engine of internal
combustion (ECOTOP)
for a\m VASES;
THE GAS; IZH; UAZ, ZIL, SLOT,
patent RFpp 2165031
2006ó.
Write
AUTHOR:
ecolog@samaramail.ru
With respect,d.t.n.,Academician to Ecology Valeriy DUDYSHEV! Tel:(846)336-86-67